miniland warmy twin Mode D'emploi page 18

ENGLISH
2. Insert the AC plug (4) into an electrical socket.
3. Subsequently, add enough water to the tank to cover the receptacles halfway up
their contents.
4. Insert the heating basket (5) into the main body as well as any receptacles which
you wish to heat.
IMPORTANT: Always use the heating basket. The baby bottles or jars of baby
food must never come into direct contact with the heater, since this could mean
that heating is not optimal and the baby bottle/jar of baby food could be damaged.
5. Place the hood (6) over the main body of the device.
6. Select the temperature hold/defrost function (9) on the device and increase or
decrease the temperature until you reach the value to which you wish to heath your
baby bottles/jars of baby food. After five seconds, the green light will change to red,
meaning that the device has started the heating cycle.
NOTE 1: The contents of the receptacle will take between 30 and 60 minutes to reach
the temperature set, according to the material, the volume of the contents in the
receptacle(s), and the initial temperature of the contents, etc.
7. The temperature will be held as long as may be necessary as long as the liquid in
the basin stays in contact with the receptacle inserted.
8. If it is not stopped manually, the device will terminate the temperature holding
process once all the water in the tank has been used.
5.4. FUNCTION 3: STERILISATION
In order to perform the sterilisation function, follow the following instructions:
1. Place the device on a suitably flat surface, making sure that it is out of the reach
of children.
2. Insert the AC plug (4) into an electrical socket.
3. Add 100 ml of water to the heating chamber.
4. Place the baby bottle(s) face down inside the heating basket (5) together with any
other accessories (nipples, dummies, etc.).
5. Place the hood (6) over the main body of the device.
6. Subsequently, select the sterilisation function (10) on the device and by default
eight minutes will appear on the screen as the time assigned to the process.
7. Increase or reduce the time according to your requirements. After five seconds, the
green light will change to red, meaning that the device has started the heating cycle.
NOTE 1: The steam which is released during the sterilisation process is very hot The
device must not be touched whilst it is being used.
8. The status indicator light and the device's heater will power themselves down
automatically when the sterilisation process has concluded. It is recommended that
you allow the device to cool down for a few minutes before opening the cover. After
this, remove the baby bottles and accessories.
NOTE 2: Allow the steriliser to cool down for at least 20 minutes before sterilising again.
NOTE 3: After the necessary cooling of the heating chamber, always remove any
remaining water from the it after each use, making sure that you leave it completely dry.
NOTE 4: If you wish to terminate the heating or sterilisation process before the time
indicated runs out, keep the power button (14) pushed down for four seconds.
18