Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
Solar power bank Mega 24000 SL-240
Item No. 1662034
Intended use
The product is intended for use as a mobile spare battery and is suitable for charging
the rechargeable battery of mobile devices (e.g. tablet PC, smartphone, MP3 player, digital
camera, etc.). The internal, integrated battery is charged via USB or via the solar panel. The
product is equipped with a robust housing and has a battery level indicator and an LED torch.
With correctly sealed covers, the product is dust- and waterproof according to IP67. When the
covers are closed correctly, the product is protected against temporary immersion in water
(max. 30 minutes up to 1 m depth).
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, fire, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements. All company and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Solar power bank
• Micro USB charging cable (Micro USB/USB-A), approx. 30 cm in length
• USB-C
charging cable (USB-C
/USB-A), approx. 30 cm in length
TM
TM
• Carabiner
• Operating instructions
Latest operating instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in a triangle indicates that there is a risk to your health,
e.g. due to an electric shock.
The symbol with an exclamation mark in a triangle is used to highlight important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on how to use the
product.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
a) General
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. It may become a
dangerous toy for children.
• Protect the product from extreme temperatures, impacts, flammable gases,
vapours and solvents.
• The product is waterproof according to IP67 only when all covers are correctly
closed.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stress.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Attention, LED light:
- Do not look directly at the LED light!
- Do not look into the beam directly or with optical instruments!
• Never use the product immediately after it has been brought from a cold room
into a warm one. The condensation generated could destroy the product. Allow
the device to reach room temperature before connecting and using it. This may
take several hours.
• Never leave the product unattended during use.
• The housing warms up during use. Ensure that there is sufficient ventilation. Do
not cover the housing!
• Do not expose the product to direct sunlight when the internal battery is fully
charged.
• Do not store the product in a heated vehicle. Avoid excessive heat (up to 45 °C).
Observe the information in the "Technical data" section.
• Make sure that the cable is not pinched, kinked or damaged by sharp edges.
• Store the product at a cool, dry location when it is not in use.
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) Battery
• The rechargeable battery is built into the product and cannot be replaced.
• Never damage the rechargeable battery. Damaging the casing of the rechargeable
battery might cause an explosion or a fire! Unlike conventional batteries (e.g.
AA or AAA batteries), the casing of the LiPo rechargeable battery is made of a
sensitive plastic film.
• Never short-circuit the contacts of the rechargeable battery. Do not throw the
battery or the product into fire. This may cause a fire or explosion!
• Charge the battery regularly, even when you are not using the product. You do not
need to discharge the battery before recharging it.
• Never leave the battery unattended when it is charging.
• Place the product on a heat-resistant surface before charging the battery. The
product may become warm when the battery is charging.
Operating elements
1
2
10 9
8
7
6
1 Function switch
2 Battery level indicator
3 Solar panel
4 Solar charging lamp
5 Eyelet for carabiner hook
Charging the battery
Fully charge the built-in rechargeable battery before first use.
Never charge the internal battery while an external mobile device is being charged.
Before charging the internal battery, ensure that the USB power source can deliver
a sufficient charging current, otherwise you may damage the product.
Do not use a USB port on a computer, keyboard or USB hub without power adapter
to charge the internal battery, as the current supplied by these ports is not sufficient.
When charging the product via USB, make sure that no sunlight falls on the solar
panel. Otherwise, the internal rechargeable battery may overheat.
Ensure that the connected devices' specifications conform to the product's
specifications listed in the technical data section.
Do not short-circuit the USB inputs/outputs.
3
4
5
6 LED torch
7 USB-A output 1, top
8 USB-A output 2, bottom (orange)
9 Micro-USB input
10 USB-C
input/output
TM
Publicité
Table des Matières
