Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
PB-9 POWERBANK, 15000 mAh
ITEM NO.: 1270361
INTENDED USE
This product is a portable charging device and is designed to charge batteries in mobile
devices such as smartphones. A mini LED flashlight is built into the power bank. The built-in
internal battery is charged via USB. The product features a battery level indicator and is
protected against overcharging, overload and short circuits.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If
you use the product for purposes other than those described above, the product may be
damaged. In addition, improper use can cause hazards such as short circuiting, fire, electric
shock etc. Read the instructions carefully and keep them. Make this product available to third
parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
DELIVERY CONTENT
• Powerbank
• Micro-USB cable (approx. 40 cm long)
• Operating instructions
SAFETY INSTRUCTIONS
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Never pour any liquids over electrical devices or put objects filled with liquid right
next to the device. If liquids or objects do get into the device interior, the product
must not be used any more; take the product to a repair centre.
• Never use the product immediately after it has been brought from a cold room into
a warm one. The condensation generated could destroy the product. Allow the
product to reach room temperature before connecting it to the power supply and
putting it to use. This may take several hours.
• Never leave the product unattended during use.
• The device housing warms up during operation. Ensure that there is sufficient
ventilation. The device housing must not be covered!
• Attention, LED light: Do not look directly into the LED light! Do not look into the
beam directly or with optical instruments!
• Make sure that the cable is not pinched, kinked or damaged by sharp edges.
b) Rechargeable batteries
• The rechargeable battery is permanently built into the product and cannot be
replaced.
• Never damage the rechargeable battery. Damaging the casing of the
rechargeable battery might cause an explosion or a fire!
• Never short-circuit the contacts of the rechargeable battery. Do not throw the
rechargeable battery or the product into fire. There is a danger of fire and
explosion!
VERSION 12/14
• Charge the rechargeable battery regularly, even if you do are not using the
product. Due to the rechargeable battery technology being used, you do not need
to discharge the rechargeable battery first.
• Never charge the rechargeable battery of the product unattended.
• When charging, place the product on a surface that is not heat-sensitive. It is
normal that a certain amount of heat is generated during charging.
c) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
If you are not sure about the correct connection or use, or if questions arise which are not
covered by these operating instructions, please do not hesitate to contact our technical
support or another qualified specialist.
OPERATING ELEMENTS
1
2
1 Battery level display
2 Multifunction button
3 USB-A port OUT 5 V / 1A (output)
OPERATION
Check the battery level of the internal battery before each use.
Ensure that the connection specifications for your mobile device comply with
the connection data for the product (see technical data).
Always read the operating instructions for your mobile device.
Do not short-circuit the USB ports.
The USB cable is not designed for data transfer.
a) Checking the battery level
1. To check the level of the internal battery, briefly press the multifunction button (2). The
battery level will be displayed as follows on the battery level display (1).
b) Charging the internal battery
1. Charge the internal battery of the power bank when a battery level of below 25% is
indicated (1 LED on).
2. Connect the micro USB adapter to the micro USB port IN (4) on the power bank.
3. Connect the USB-A connector on the USB cable to a USB port on a computer or another
suitable USB power source, such as a USB power adapter. Charging begins as soon as
the USB power source delivers a current.
4. The battery level display LEDs (1) flash to indicate that the internal battery is charging. The
total number of LEDs alight indicates the current battery level of the internal battery.
5. The 4 LEDs will all be constant when the power bank is fully charged; the power bank
turns itself off. The battery level display (1) turns off after about 15 seconds.
4 Micro USB port IN (input)
5 USB-A port OUT 5 V / 2.1A (output)
6 LED light
Remaining capacity up to 25%
Remaining capacity up to 50 %
Remaining capacity up to 75 %
Remaining capacity up to 100 %
The current battery level is displayed during charging.
The position of the flashing LED indicates the current battery level
during charging (the battery is 75% charged).
3
6
4
5
Publicité
Table des Matières
