Important Safety Instructions - Uberhaus PH-822 Guide De L'utilisateur

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS HEATER
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE RISK OF FIRE, ELECTRICAL SHOCK AND INJURY TO PERSONS
OR PROPERTY, INCLUDING THE FOLLOWING:
When switching on the appliance for the first time, allow it to run at full
power for about two hours to get rid of the unpleasant smell. Make sure
that the room in which the appliance is located is well ventilated during this
operation. It is normal for the appliance to emit small cracking sounds when
you turn it on if the first time.
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. Use the handle (if provided) when moving the unit. Keep combustible
materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3"
(0.9 m) from the front and top of the radiator and keep them away from the sides and
rear. Keep the rear grille away from walls or drapes so as not to block the air intake.
3. Caution and supervision are necessary when any heater is used near children or pets
and whenever the heater is left operating unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return the heater to an
authorized service facility for examination, electrical or mechanical adjustment or
repair.
6. Do not use outdoors.
7. This heater is not intended for use in any area where there is standing water. Never
locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or
similar items.
Do not route cord under furniture or appliances.
high traffic areas where it will not be tripped over.
9. To disconnect the heater, turn controls to OFF, then remove the plug from the
outlet.
10. Connect to properly polarized outlets only.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause electric shock, fire or damage to the heater.
12. To prevent possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces like a bed, where openings may become blocked.
13. A heater has hot, arcing or sparking pads inside. Do not use it in areas where
gasoline, paint or flammable liquids are used or stored.
14. Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, injury to persons or other damage to
property.
15. To prevent overload and blown fuses, be sure that no other appliance is plugged into
the same outlet or into another outlet wired into the same circuit.
16. It is normal for the heater's plug and cord to feel warm to the touch. A plug or cord
which becomes hot to the touch or becomes distorted in shape may be a result of a
worn electrical outlet. Worn outlets or receptacles should be replaced prior to
Arrange cord away from
3