Troubleshooting; Disposal Of The Old Device - CASO DESIGN CB 2200 Mode D'emploi

17.2 Troubleshooting

The Device does not work.
The appliance is not plugged in.
The glass bowl is not placed on base unit. Place the glass bowl properly with guided
The lid is not placed/ fitted well onto the
glass bowl.
The ingredients have not blended well.
The ingredients exceeded the Max
indication in the glass bowl.
The water or cooking liquid is not
enough to blend well
The food is burnt.
The water or cooking liquid is not enough. Make sure the water/ cooking liquid level is
No response or the sensitivity of control panel is getting low by pressing several
times on function keys.
Appliance is under electromagnetic
interference.
Dirt on control panel.
Attention
► If above mentioned steps don't solve the problem, please contact your customer
service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable waste under
any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
Caso Mixer mit Kochfunktion CB 2200
Please note
Check the appliance mains plug is connected
in the socket properly.
grooves.
Place the lid properly onto the glass bowl and
make sure it fits properly.
Remove some of the ingredients and ensure
the ingredients are placed evenly over the
bottom of the glass bowl.
Make sure the water/liquid level is correct as
mentioned in the recipe.
correct as mentioned in the recipe.
Unplug the appliance from power socket.
Restart after few minutes.
Clean the panel with soft cloth.
49