Setup Location Requirements; Electrical Connection - CASO DESIGN CB 2200 Mode D'emploi

13.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
 The appliance must be positioned on a solid, even, horizontal and heat-resistant base with
sufficient load-supporting capacity for the appliance itself plus the heaviest anticipated
cooking contents.
 Do not operate the appliance near wall or outlet to prevent damage from steam.
 Do not let cord hang over the edge of table or counter or touch hot surface.
 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
 The installation and assembly of this device in non-stationary setup locations (e.g. on ships)
must be carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.

13.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs
is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
 The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a
protective conductor are prohibited. If in doubt, have the house installation checked over by
a qualified electrician. The manufacturer cannot be made responsible for damages that are
caused by a missing or damaged protective conductor.
Caso Mixer mit Kochfunktion CB 2200 40