Emerson AIRA ECO CF985BS00 Mode D'emploi page 16

8. Installation of Downlight Assembly
If using the No-light Cover Plate, skip this section and
go to Section 9.
8.6
Light Fitter Light Bulb Installation:
If light fitter is to be used as a down light, screw in two
50-watt (maximum) mini-candelabra base halogen bulbs
CAUTION: To avoid risk of burns or other injury,
(supplied) into the light fitter sockets (Figure 28).
assure power is off before attempting to install or
replace the 50-watt (max.) mini-candelabra base
halogen bulbs. Halogen bulbs are very hot and can
cause burns. Allow the bulbs to cool sufficiently
before handling.
CAUTION: Do not touch 50-watt (max.) mini-
candelabra base halogen bulbs with bare hands.
Fingerprints may result in shorter bulb life. Remove
fingerprints with alcohol.
8.7
Place the light fitter glass bowl into the light fitter, aligning
the three flat areas on the top flange of the glass bowl with
the three raised studs in the light fitter.
Then turn the glass bowl clockwise until it stops and is
NOTE: Periodically check that the glass bowl is seated
secure (Figure 29).
fully clockwise in the light fitter.
Installation of your ceiling fan is now complete. Proceed
with installation of the wall control.
Proceed to Section 10 to install the wall control.
LIGHT
FITTER
Figure 28
LIGHT FITTER
LIFT GLASS BOWL UP
RAISED STUDS (3) INTO LIGHT FITTER
GLASS
BOWL
ROTATE GLASS BOWL CLOCKWISE TO
ENGAGE ON THE LIGHT FITTER RAISED STUDS
Figure 29
16
(Continued)
LIGHT FITTER
SOCKETS (2)
50-WATT (max.)
MINI-CANDELABRA BASE
HALOGEN BULBS (2)
FLAT AREA
OF GLASS
BOWL (3)
E.T.L. Model No.: CF985