Replacing The Oven Light; Removing The Storage Drawer - IKEA MOTSVARIG Mode D'emploi

CARE AND CLEANING

Replacing the Oven Light

CAUTION
Be sure the oven is unplugged and all parts are
cool before replacing the oven light.
Replacing the oven interior light bulb:
The interior oven light is located at the rear of the
oven cavity and covered with a glass shield. The
glass shield must be in place whenever the oven
is in use.
1. Turn electrical power off at the main source or
unplug the appliance.
2. Remove the interior oven light shield after
removing the wire holder by carefully moving
the wire to the side of the glass shield. The
tension from the wire holds the glass shield in
place.
3. Pull the shield straight out. Do not twist or
turn.
4. Replace the bulb with a new appliance bulb.
5. Replace the glass oven light shield. Replace
wire holder.
6. Turn the power back on again at the main
source (or plug the appliance back in).
7. Be sure to reset the time of day on the clock.
glass
shield
wire
holder
Figure 20: Oven light protected by glass shield
34

Removing the Storage Drawer

Use the storage drawer for storing cooking utensils.
The drawer can be removed to facilitate cleaning
under the range. Use care when handling the
drawer.
Figure 21: Open storage drawer
Figure 22: Closed storage drawer
Cleaning under bake element
The bake element is located in the lower oven cavity.
For some models, if the lower bake element is visible
it may be tilted up for easier access to the oven bot-
tom for cleaning. Remove the oven racks before rais-
ing the element. Be careful not to raise the element
more than 4 or 5 inches from the resting position.
EN