Stack ST100 Guide D'installation page 2

Mounting
1. Mount the tachometer in a 86mm dia.
cut out in the dashboard. (Be careful not
to cut the hole too large.)
2. Cut a 10mm dia. hole in the firewall for
the tachometer wires. Place included
rubber grommet in the hole and route
the connector wires through the
grommet to the engine compartment.
3. Connect the tachometer wires as shown
in the Wiring Section.
4. Secure tachometer to dashboard using
the provided bracket & hardware.
WIRING
WARNING
Warranty will be void if connected to
coil when using an aftermarket ignition
box such as, but not limited to products
from the following manufacturers: MSD,
Crane, Jacobs, Mallory, Holley, Etc.. Prior
to installation of your tachometer, check
with the ignition box manufacturer for
recommended tachometer signal location.
STACK, Ltd. warrants to the consumer that all STACK products will be free from defects in material and workmanship for a period of twelve (12) months from date of the original purchase. Products that fail within
this 12 month warranty period will be repaired or replaced at STACK's option to the consumer, when it is determined by STACK, Ltd. that the product failed due to defects in material or workmanship. This warranty
is limited to the repair or replacement of parts in the STACK instruments. In no event shall this warranty exceed the original purchase price of the STACK instruments nor shall STACK, Ltd. be responsible for
special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to STACK must be transportation prepaid and accompanied with dated proof of purchase. This
warranty applies only to the original purchaser of product and is non-transferable. All implied warranties shall be limited in duration to the said 12 month warranty period. Breaking the instrument seal, improper use
or installation, accident, water damage, abuse, unauthorized repairs or alterations voids this warranty. STACK, Ltd. disclaims any liability for consequential damages due to breach of any written or implied warranty
on all products manufactured by STACK.
FOR SERVICE SEND TO: STACK LIMITED
©2017 Stack LTD
95.25mm
3A
Fuse
As a safety precaution, the +12 V terminal of this product should be fused
before connecting it to the 12V ignition switch. We recommend using a 3 Amp,
automotive fuse or equivalent to help protect this product.
12 MONTH LIMITED WARRANTY
413 W. Elm St., Sycamore, IL 60178 USA toll free (888) 867-5183
or international (815) 991-2134 Email us at sales@stackltd.com
45mm
+12V IGNITION
SWITCH
SEE WARNING BELOW
_
GROMMET
IN FIREWALL
COIL
LIGHT WIRE
- DASH
LIGHTING
CIRCUIT OR
12 VOLT (+)
EARLY
MODEL
IGNITION
CAUTION!
85mm
- OR -
+
ELECTRONIC IGNITION
or
ECU
TACH
TERMINAL
2650-1929-77 6-16-17