Operating Tips - VALERA PRO STYLE 400 TOURMALINE Instructions Pour L'utilisation

Sèche-cheveux multistyler
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
too high. Should this happen, move the switch to the 0 position and leave
it to cool for 5 minutes.
•Always allow the unit to cool before putting it away and never wrap the cord
around the unit.
•Check that the cord has not been damaged from time to time.
•The elements used to pack the unit (plastic bags, cardboard box, etc.) must
be kept out of reach of children as they are a potential danger to them.
•This unit must only be used for the purposes for which it is expressly
intended. Any other use is to be considered improper and therefore
dangerous. The manufacturer accepts no responsibility for damage
caused by improper or erroneous use.
•Do not use hair spray while the unit is running.
•To avoid dangerous overheating, it is advisable to unwind the entire length
of the cord.
•Warning - The metal parts overheat if used for too long. Be careful and
allow these parts to cool before touching them.
Important
This hairdryer conforms to the safety regulations regarding electrical appliances.
This hairdryer has a safety cut-out which will operate in case of overheating. The dryer will re-
set itself after being left to cool for a few minutes, but please check air inlet and outlet grills are
clear before continuing to use the dryer.
OPERATING INSTRUCTIONS
Switch position
0 = Off
1 = hot air / low air flow
2 = very hot air / strong air flow
= lukewarm air
• Changing Voltage
Before use select the voltage to be used - 115V or 230V - depending on your power supply voltage.
To turn the voltage selector on the unit's handle, use a small screwdriver or some similar object.
• Accessories
1 Retractable combs thermal brush for tangle free waves & curls, Ø 30 mm
1 Thermal bristles with massaging bristles for volume & shine, Ø 25 mm
• Applying/changing accessories
Fit the accessory on the unit so that the reference marks ►◄ correspond and then turn the ring nut on
the unit anticlockwise until the symbols are aligned with one another (►●). To remove or change an
accessory, turn the ring nut clockwise back to the start position ►◄, then the accessory can be
removed easily.

OPERATING TIPS:

1. Before using this unit, wash your hair and towel dry.
2. Plug the unit into the power supply socket.
3. Dry your hair using this unit without any accessories, before adding shape using the brushes.
4. Hair that has just been washed and dried can be styled better.
5. The first few times you use this unit it is advisable to practice on small areas of your hair.
USING THE VARIOUS ACCESSORIES
• Retractable combs thermal brush for tangle free waves & curls, Ø 30 mm
This is designed to create curls and waves quickly. In addition, the metal coating means that the hair
style stays in place . To style your hair using this accessory - With the unit off make the bristles stick
out of the metal casing by turning the ring nut at the top of it clockwise until it stops turning. Then
wind a lock of hair around the brush, starting from the ends and working towards the roots. Switch
the unit on and briefly heat your hair, putting the switch in position 1 or 2. For better hold, let the locks
cool in position
for a few seconds. To release your hair the lock need not be unrolled, simply turn
the ring nut at the end of the brush anticlockwise to retract the bristles into the metal casing. Then pull
the brush out of the curl.
• Thermal bristles with massaging bristles for volume & shine, Ø 25 mm
It is particularly recommended for brushing hair, leaving it shiny and volumised. Plus, as you are
brushing, the rounded bristle tips also massage the scalp.
Important: This accessory is not designed to create curls, as hair could become tangled up in the
bristles when each section is unrolled.
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

602.01

Table des Matières