Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating instructions Wiring Duct Cutter
2.2 Additional safety requirements for the handling of the Wiring duct cutter
•
Set-up, commissioning and reparation of this equipment must only be performed by qualified personnel that has read and understood this manual.
•
Safety mechanisms must not be removed or deactivated.
For damages, provoked by improper installation or non-compliance of the safety requirements, häwa GmbH & Co.KG can not be made liable.
3 Handling of the equipment
The wiring duct cutter is state-of-the-art and in accordance with the relevant safety regulations at time of placing on the market, and with regards to its
intended application.
We reserve technical modifications as part of further developments of the machine.
3.1 Intended use
The wiring duct cutter has been developed for cutting ducts to length in a clean and effortless way.
The use of the wiring duct cutter must follow along with the guidelines of this manual.
Each and every inappropriate usage are considered unauthorized handling and therefore outside of the manufacturer's limit of liability.
3.2 Predictable misuse / improper handling
With every modification of the machine and with predictable misuse or improper handling of the wiring duct cutter the operating license ceases to exist.
Predictable misuse / improper handling:
•
Cutting of materials other than approved in the manual, as for example: Aluminum, copper, steel, lead, glass etc.
•
Outdoor use
•
Use with removed protective gear
•
Unsecured use
•
Incorrectly executed repairs
•
Non-intended use
3.3 Residual risks
Not all risks could be avoided structurally without confinement of its intended use. The residual risks of the wiring duct cutter have been analyzed with a
risk assessment.
Possible residual risks that cannot be avoided structurally could be:
•
Bruises or cutting of limbs through disregard of this instruction manual
•
Unintended operation / turning-on of equipment
•
Cutting injuries through tools or sharp sheet metal
Residual risks can be avoided by doing the following:
•
Vigilant working
•
Paying attention to all notes on the equipment and in this manual
•
Following the general safety stipulations / regulations
4. Scope of delivery
•
Cutter
•
Hand lever
•
Length stop 39.37"
8
Publicité
Chapitres
Table des Matières
