Stop Assembly; Code Of Practice; Length Stop Adjustment - hawa 2677 Mode D'emploi

Operating instructions Wiring Duct Cutter
5.3 Stop assembly (fig. 3)
Secure the 39.37" length stop at the right side of the wiring duct cutter with the counter-sunk screws M8.
Base support is not required. Follow the same installation procedure for the optional 78.75" length stop.
Fig. 3
Before operating, bolt the wiring duct cutter to a suitable table or rack (pay attention to correct height for fatigue-proof operation).
The use of extended supports for wiring ducts and covers is recommended.

6. Code of practice

Attention: Protective covers must not be disassembled.
Attention: To avoid damage to cutter blades do not cut duct with snap-on covers or any other kind of covers or reinforcements in place.
6.1 Length stop adjustment (fig. 4)
Continuous adjustment from 2.75" to 39.37" (optional stop can be adjusted from 2.75" to 78.74").
Measuring scale at the right side of the stop indicates adjusted length.
Fig. 4
70-1000 mm (2000)
2,76"-39,4" (78,7")
10