Lubrication - sunjoe SJSW26M Manuel D'utilisation

Maintenance
General
• After each use, dump and clean the hopper.
• Rinse/dry inside and outside of the sweeper after
each use.
• Periodically check all nuts, bolts, and screws for
proper tightness.
• Annually clean out and lightly lubricate parts.
• Use a glossy enamel spray paint to touch up scratched or
worn painted metal surface.
• Never exceed the hopper load capacity rating of
52.3 gal (198 l) It will damage the hopper bag.

Lubrication

The bearings in the sweeper have been pre-lubricated at the
factory. However it's recommended that a few drops of light oil
should be added to the brush shaft bearings twice a year. Also,
the gear should be cleaned every two years. After cleaning
apply an even coat of light grease.
1. Use a screw driver to pop off the hub cap (Fig. 13).
Fig. 13
Hub cap
2. To remove the wheel, take out the circlip and the flat
washer; you will see the gear and the shaft (Fig. 14).
Fig. 14
Flat washer
Circlip
3. Remove the circlip on the gear, the gear can be taken off
easily (Fig. 15).
Fig. 15
Circlip
4. Clean the gear and lubricate the shaft as needed, then
reassemble the wheel in a reverse sequence.
7
Gear
Shaft
Wheel
Gear