sunjoe SJSW26M Manuel D'utilisation page 4

Assembly
Your push lawn sweeper requires assembly. Account for all
parts and hardware before beginning assemble. If any parts
are missing or damaged, or if you have any questions or need
additional instructions, please call the Snow Joe
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
Tools needed:
• Pliers
• 10 mm wrench
1. Attach the supporting leg to the sweeper assembly and
secure with a M6 x 30 hex bolt, lock washer, and M6 lock
nut (Fig. 1). Do not tighten yet. Repeat for the other side.
M6 lock nut
Fig. 1
Lock washer
2. Assemble the handle frame over the supporting legs. Align
the holes in the handle frame and supporting legs (Fig. 2).
Fig. 2
Handle frame
3. Secure the supporting legs and the handle frame with two
M6 x 30 carriage bolts, bag rod clips, lock washers, and
handle knobs (Fig. 3).
Fig. 3
+ Sun Joe
® ®
Support leg
4. Fully tighten all hardware in step 1.
5. Put two bag rod clips on the inside of each supporting leg,
secure by a M6 x 30 carriage bolt, a lock washer, and a
M6 x 30
handle knob (Fig. 4).
hex bolt
Sweeper
Fig. 4
assembly
Supporting
leg
4
Lock washer
Handle
knob
Supporting
leg
Bag rod
clip
Handle knob
Lock washer
Bag rod clip
Handle
frame
M6 x 30
carriage
bolt
M6 x 30
carriage bolt