Installation Of Finished Installation Kit - Franke PR3O0020 Notice De Montage Et De Mise En Service

☞
The various wire guides are marked with numbers 1 to 4.
A: Union nut
B: FAR-Best.-Nr. 2000104272
FAR-Best.-Nr. 2000104274
FAR-Best.-Nr. 2000100801
FAR-Best.-Nr. 2000100852
10.15 Push the wires (o) into the wire guides (p) according to their colours.
10.16 Cut off the projecting wire ends flush, i.e. without protrusions.
10.17 Push the union nut (n) onto the electrical T-distributor (k) and tighten it to the
required torque (1.2 Nm).
Caution!
Note the polarity.
The same wire colour must be in the same wire guide for both union nuts.
☞
When tightening the union nut, the electrical contact and tension relief are created
automatically.
Special seals act as protection from dust and water.
10.18 Open the water volume regulator using an Allen key.
r: closed
s: open
10.19 Flush the pipes according to DIN 1988.
10.20 Check the water connections for leaks.
10.21 Insert the wall protection.

11. Installation of finished installation kit

Warning!
Only operate the fitting with non-return valves and the specified filters.
Failure to observe this instruction can result in an increased germ load in the
drinking water and thus pose a health or mortality risk.
☞
Important!
Prior to the assembly process, flush the pipework in accordance with DIN 1988.
11.1 Remove the wall protection.
11.2 Close the water volume regulators (see
11.3 Open the locking screws (a) of the water quantity regulators (d).
☞
Important!
Note the installation position of the filters (b).
11.4 Insert the filters (b).
11.5 Screw in the locking screws (a).
8
A
1 brown
2 white
3 blue
4 black
Work step 10.18).
B
red
white
blue
black