Cleaning And Maintenance - Transistor Lynx TX-1 Manuel

Troubleshooting
Type of fault
Lynx TX-1 fails to send out alarm.
Receiver fails to respond.

Cleaning and maintenance

Vacuum outside of Lynx TX-1 with a soft brush several times per year. Use a lightly moistened cloth to
dry off the exterior. Never use cleaning products or solvents.
Repairs
If the product malfunctions it must be repaired by an authorised technician. Do not attempt to open
the case of the device since this would invalidate the warranty. If your product requires service, please
contact your hearing care professional for assistance.
Waste disposal
This product contains electrical or electronic equipment and should be disposed of carefully
in the interest of your safety and the environment. Please contact your local hearing care
professional concerning disposal of the product.
General Precautions
• Low-energy radiation (eg from burglary alarms, room surveillance systems, radio equipment, mobile
telephones) will not damage the device.
• Warning: External devices connected to the product must be safe according the requirements of EN
60601-1-1, EN 60335-1 or EN 60065, as appropriate.
Technical data
Modulation: AM.
Frequency: 433.92 MHz.
Range: >50 m free line of sight to repeater or receiver. Shorter range indoors.
Channels: 16 via microswitches.
Functions: 1 of 7 options is available.
Telephone input: Modular jack.
Other inputs: 0.7-24 V AC/DC and short circuit.
Battery: 1 x 9 V type 6LR61 or IEC 6F22.
Any issues relating to the EU Medical Device Directive
93/42/EEC should be directed to AB Transistor Sweden.
Action:
1. Check that the battery is OK.
2. Check that the cables are properly fitted.
Check the range. Try to reduce the distance
between Lynx TX-1 and the receiver or install a
Repeater to extend the range.
ENGLISH
7