Main Switch; Indicator Led's; Operation - Hayward Aqua Trol AQ-TROL-RJLS-CUL Manuel Du Propriétaire

Operation

Controls
The pool filter pump should run long enough to circulate the entire volume of pool water each day.
This will vary depending on pump size, pool plumbing and pool size. Consult a local pool store to help
determine the appropriate run time for your pool.

Main Switch

AUTO: For normal operation, the Main Switch should be left in the AUTO position. In this position
the Aqua Trol will produce chlorine according to the "Desired Output %" adjustment setting for the
entire filtering/pumping cycle.
SUPER CHLORINATE: When you have an abnormally high bather load, a large amount of rain,
a cloudy water condition, or any other condition which needs a large amount of purification to be
introduced, put the Main Switch in the SUPER CHLORINATE position. This electronically "super chlo-
rinates" (shocks) the water for 24 hours (filter pump must be on during this time) or until the power
has been turned off, whichever comes first. At the end of the super chlorinate time, be sure to put
the switch back into the AUTO position.
OFF: The OFF position prevents the Aqua Trol from energizing the electrolytic cell. In this position
there is no chlorine generation. NOTE: To service any of the pool equipment or the Aqua Trol, turn
the power off at the circuit breaker.
Desired Output % adjustment knob
This setting is used to control the amount of chlorine the Aqua Trol generates. Raise this setting to
increase chlorine level and lower it to decrease chlorine level.

Indicator LED's

POWER When illuminated, the Aqua Trol has input power.
GENERATING This LED is on steady during normal operation. When flashing, the pool water is too
hot or cold to operate.
SUPER CHLORINATE Illuminates during Super Chlorination. See description above.
NO FLOW When illuminated, the flow switch has detected no flow and the Aqua Trol has stopped
generating chlorine. A flashing LED indicates a 15/60 second time delay period.
TEST SALT LEVEL When flashing, the salt level is low (below 1200 ppm) and Aqua Trol is generat-
ing at low efficiency. When illuminated steady, the salt level is too low and Aqua Trol has shut down.
Before adding large quantities of salt, it is advisable to have your salt level professionally checked.
HIGH SALT When illuminated, the salt level is too high and Aqua Trol has shut down.
INSPECT CELL A flashing indicator signifies that either the cell efficiency is reduced or that it is
time for regularly scheduled cell inspection. In either case, inspect the cell and clean if necessary.
Pressing the "diagnostic" button next to the display for 3 seconds will stop the flashing LED. When il-
luminated steady, cell efficiency is greatly reduced and the Aqua Trol has stopped producing chlorine.
Inspect, clean or replace if necessary.
5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS