OHAUS PX Serie Mode D'emploi page 6

EN-4
Button
Menu
 Accepts the current
Function
(Short
Press)
DISPLAY
Net (NET)
Stability (*)
Negative (-)
Centre of Zero (>0<)
Preset tare (PT)
Instructional Messages
3.2 Principal Functions
Zeroing:
Taring:
Weighing:
Dot-matrix
Display:
4. MAINTENANCE
4.1 Cleaning
WARNING: Disconnect the balance from the power supply before cleaning.
Make sure that no liquid enters the interior of the balance.
Clean the balance at regular intervals.
Housing surfaces may be cleaned with a lint-free cloth slightly dampened with water or a
mild cleaning agent.
Glass surfaces may be cleaned with a commercial glass cleaner.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
4.2 Troubleshooting
If the troubleshooting section does not resolve your problem, contact an Authorized Ohaus Service
Agent. Please visit our website www.ohaus.com to locate the Ohaus office nearest you.
Yes
 Rejects the current
(blinking) setting on
the display.
 Increments a value
Press Zero to zero the balance.
With no load on the pan, press
empty container on the pan and press Tare. Add material to the container
and its net weight is displayed. After the container and the objects are
removed, the tare value will be displayed as a negative number. Press Tare
to clear.
First press Zero to set the display to zero. Place an object on the pan. The
display indicates the gross weight.
The relevant data in the specific application mode are shown in the dot-
matrix display area.
No
 Reverts back to
(blinking) setting on
the display.
 Decrements a value
being entered.
Zero to set the display to zero. Place an
Back
 Immediately exits
previous menu
 Aborts a
item.
being entered.
Exit
the sub-menu.
calibration in
progress.
Result Field:
Information varies by
application
Unit