Guidelines For Treatment; Average Treatment Time - Philips SC2003/00 Mode D'emploi

Masquer les pouces Voir aussi pour SC2003/00:

Mode d'emploi (90 pages)

Mode d'emploi (118 pages)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

Table des Matières

Les langues disponibles

Area

Underarms

Bikini line

Entire bikini area

Press the flash button to release a flash. Now you have 2 options to

release the next flash:

A Keep the flash button pressed. The appliance releases one flash

after another as long as the safety ring is in full contact with the skin.

Immediately after the appliance has flashed, slide the appliance to the

next area. Make sure the safety ring is fully pressed onto the skin.

This 'Slide & Flash mode' is especially convenient for treatment of larger

areas like the legs.

B Let go of the flash button after each flash. For the next flash, place the

appliance on the area right next to the previously flashed area. Make

sure the safety ring is fully pressed onto the skin.

This 'Step & Flash mode' guarantees a precise treatment of e.g. the upper

lip, knees or ankles.

Note: After a few seconds, the appliance is ready to flash again, so make sure

that you move it to the next area immediately after it has flashed.

Do not treat exactly the same area multiple times during one session.

This does not improve the effectiveness of the treatment, but increases

the risk of skin reactions.

Note: The visible light produced by the appliance is the reflection of the flash

on the skin and is harmless to your eyes. It is not necessary to wear goggles

during use.

To avoid untreated areas, always make sure there is a slight overlap

with the previously treated area when you place the appliance on the

skin. The effective light only comes out of the light exit window. Make

sure the flashes are produced close to each other.

Switch off the appliance after you have finished the treatment.

Check the light exit window and the attachment for hairs and

dirt and clean the appliance after use (see chapter 'Cleaning and

maintenance').