Assembly (And Disassembly) Of Two Tops (Mono Configuration) - dB Technologies ES-1203 Caractéristiques Techniques

ASSEMBLY (AND DISASSEMBLY) OF TWO TOPS (MONO CONFIGURATION)

In the mono configuration, you must
assemble the two tops (ES1203TOP) with
one on top of the other.
Each top features two sides.
One side has a 36 mm diameter hole [X]
for inserting the pole.
The other side has a locking system with
a rear safety lever [K].
!
CAUTION
• BEFORE ASSEMBLY, MAKE
SURE THAT THE SAFETY
LEVERS [K] ARE PUSHED
INWARDS AND NOT IN
THE RELEASED POSITION
(OUTWARDS).
• Flip one of the two tops as shown in
the figure
• Place one of the two tops on the
other with the two locking systems
aligned
• Apply pressure so that the two
locking systems engage. When they
are assembled correctly, the two
rear safety levers [K] move outwards
(released position) and each makes a
"click".
To disassemble the two tops:
• Press the two rear safety levers
• Remove the two tops
ES-1203
36
English
Cod. 420120253 REV. 1.0