Power Input On Rear Panel - D-Link DGS-1016D Manuel

Power Input on Rear Panel

The power cable connection is located on the rear panel of the
Switch.
Rear panel view of the Switch
‧Switch power input is provided by and internal universal power
supply (100-240VAC, 50-60Hz, 0.4A Max : 12V/2A).
The AC power connector is a standard three-pronged connector
that supports the power cord. Please see the Power On section
below for instructions on how to properly connect the Switch to a
power source.
‧
Kensington Security Slot
DGS-1016D/24D has been giving customers the best option for
physical security through a Kensington Security Slot in the rear
panel. The Kensington Security Slot adds value to DGS-1016D/24D
by offering customers a simple, built-in security solution.
Grounding the Switch
This section describes how to connect the switch to ground. You
must complete this procedure before powering your switch.
Required Tools and Equipment
‧ Ground screws (included in the accessory kit): One M4 x 6 mm
(metric) pan-head screw
10