General Precautions For Rack-Mountable Products - D-Link DGS-1016D Manuel

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch
Safety Instructions (continued)
•
Observe the following precautions for rack stability and safety. Also refer to the
rack installation documentation accompanying the system and the rack for
specific caution statements and procedures.
•
Systems are considered to be components in a rack. Thus, "component" refers
to any system as well as to various peripherals or supporting hardware.
•
Before working on the rack, make sure that the stabilizers are secured to the
rack, extended to the floor, and that the full weight of the rack rests on the floor.
Install front and side stabilizers on a single rack or front stabilizers for joined
multiple racks before working on the rack.
General Precautions for Rack-
Mountable Products
CAUTION: Installing systems in a rack without the front
and side stabilizers installed could cause the rack to tip
over, potentially resulting in bodily injury under certain
circumstances. Therefore, always install the stabilizers
before installing components in the rack.
After installing system/components in a rack, never pull
more than one component out of the rack on its slide
assemblies at one time. The weight of more than one
extended component could cause the rack to tip over
and may result in serious injury.
vii