Assembly - GOK EN61-DS PS 16 bar Instructions De Montage Et D'utilisation

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport. The system operator may carry out ASSEMBLY work.
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
Metal chips may cause eye injuries.
Wear safety goggles!
Malfunctions caused by residues! Proper functioning is not guaranteed.
Visually check that there are no metal chips or other residues in the connections!
It is important that metal chips or other residues are blown out!
Install with suitable tools, if required.
Regarding screw connections, use a second spanner to brace against the connection nozzle.
Do not use unsuitable tools, such as pliers.
Product damaged through incorrect installation direction
Proper functioning is not guaranteed.
Observe the installation direction (marked on the product with an arrow
Screw connections
If connections leak, there is a danger of explosion, fire or suffocation!
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
Installation steps
1. Attach the hose assembly of the gas equipment to the pressure regulator.
• Brace against the nozzle of the regulator housing with a suitable spanner.
• Tighten the cap nut on the hose assembly (observe the installation instructions in the
CONNECTIONS table).
2. Remove the plastic cap from the gas cylinder and the sealing nut from the gas cylinder
valve.
3. Connect the pressure regulator to the gas cylinder.
• Screw the cap nut of the pressure regulator on to the gas cylinder valve.
• Tighten it hand-tight.
Connecting and installing hoses assemblies
• Connect hoses so that mechanical, thermal and chemical stresses are avoided:
 mechanical stress: e.g. do not pull the hose assembly over sharp edges
 thermal effect: e.g. avoid open flames, radiant heat
 chemical effect: e.g. avoid grease, oil, caustic substances
• Install hose assemblies so that they are not under tension (no bending and tensile strains
or torsion).
• Install hose assemblies so that their connections cannot loosen unintentionally.
• Connections to the pressure regulator with 90° outlet prevent the hose assembly from
being kinked.
• Observe the applicable national installation regulations for LPG systems.
Low-pressure regulator type EN61-DS PS 16 bar
Risk of injuries due to blown-out metal chips!
).
7 / 11