Aube Technologies EConnect TA7210 Guide D'installation page 5

Installation in a 4-11/16" square junction box
ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect AC power
before beginning installation.
Wiring must comply with local electrical codes. Use special CO/ALR
solderless connectors if supply wires are made of aluminum.
1 Mount the junction box on the wall. Punch out
knockout(s), install strain relief bushing(s) and feed
the supply wires and the heater wires. Punch out
another knockout to install the antenna (step 2).
3 Clean the interior side of the junction box where
the relay will be installed. Peel off the adhesive
backing of the relay module and stick the relay
inside the junction box.
5 Insert the antenna plug in the relay receptacle
until you hear a click.
Relay wires must be at the top
2 Remove the locknut from the antenna and peel
off the adhesive backing. Feed the antenna cable
through the knockout opening and mount the
antenna. Put the locknut and tighten.
N L : For 120V application
L2 L1 : For 240V application
4 Connect the supply wires and heater wires to the
relay.
See page 6 if you are connecting more than
one heater.
6 Install a cover plate on the junction box
and apply power to the heater. Do not put the
antenna cover back yet.
ELECTRICAL HAZARD
Can cause electrical shock. Install junction
box cover plate before applying power.
5
EConnect™ TA7210
To heater
69-2472EF—03