Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Guide
Link outdoor sensor to wireless network (optional)
1 Make sure the Connect light on the EIM is
flashing (see page 7).
If you have more than one wireless thermostat,
make sure to activate the wireless setup from
an EIM linked to the thermostat. For example, to
display the outdoor temperature on thermostat Y,
you must activate the wireless setup from either
EIM B or C, not A.
2 Press the Connect button on the back of the
sensor.
3 After 15 seconds, check if the thermostat is displaying a value for the outdoor
temperature reading.
If you have more than one wireless thermostat, repeat steps 1 and 3 for each thermostat.
Link remote control to wireless network (optional)
1 Make sure the Connect light on the EIM is flashing (see page 7).
If you have more than one wireless thermostat, make sure to activate the wireless setup from
an EIM linked to the thermostat. For example, to link the remote control to thermostat Y, you
must activate the wireless setup from either EIM B or C, not A.
2 Press CONNECT at the remote control.
3 When the remote control displays
Connected (after a short delay), press
DONE.
4 Press NO at the next screen to save and
exit. (Or press YES and repeat steps 1-4 to
link to another network).
69-2472EF—03
Bathroom
wireless network
Thermostat X
EIM A
Press and
release
Bedroom
wireless network
Outdoor
sensor
Thermostat Y
Remote
control
EIM B
EIM C
WIRELESS SETUP
10
CONNECT
YES
CONNECT MORE?
Press to link to
Press to save and
another network
exit
NO
Publicité
Table des Matières
