Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1 Install the Equipment Interface Module (EIM)
Determine the location
The equipment interface module (EIM) consists of a relay and an antenna. They can
be installed either in the wiring compartment of the baseboard heater or in a 4-11/16"
square junction box.
Install EIMs at a minimum distance of 2 feet (0.6 m) of each other. This minimum
distance still applies even if the EIMs are on opposite sides of a wall.
• Installing the EIM in a baseboard heater
You can install the EIM in the wiring
compartment of the baseboard heater if you
have any of the heaters listed in the following
table:
Manufacturer / brand
Cadet
Global Commander
King Electrical
Marley
Ouellet
Stelpro
TPI
The product has been tested for compatibility with the heaters listed above. If your heater
is not on the list, install the EIM on a 4-11/16" square junction box or replace your heater
with one listed.
• Installing the EIM in a 4-11/16" square junction
box
You can use a 4-11/16" square junction box in either
of the following conditions:
• You have a convector or fan-forced heater.
• You cannot install or do not wish to install the
EIM in the wiring compartment of the baseboard
heater.
The junction box can be installed anywhere in the house;
for example, near the main electrical panel.
Series
F
CCB
K, CB, KP, M
2500, BKOC, QMKC
ODBA, ODI, ODIA, OFM, OPR
CBB, N, SCA, SCAS
2900C, 2900S, 3700, 3900
3
EConnect™ TA7210
Relay
Antenna
Relay
Antenna
69-2472EF—03
Publicité
Table des Matières
