Bosch GRL250HV Consignes De Fonctionnement/Sécurité page 15

Laser Viewing Glasses (Accessory)
The laser viewing glasses filter out the
ambient light. This makes the red light of the
laser appear brighter for the eyes.
• Do not use the laser viewing glasses as
safety goggles. The laser viewing glasses
are used for improved visualization of the
laser beam, but they do not protect against
laser radiation.
• Do not use the laser viewing glasses as sun
glasses or in traffic. The laser viewing
glasses do not afford complete UV
protection and reduce color perception.
Working with the Laser Receiver
(Accessory)
Under unfavorable light conditions (bright
environment, direct sunlight) and for larger
distances, use the laser receiver for improved
finding of the laser beam 23
When working with the laser receiver, select
rotational operation with the highest
rotational speed.
Before working with the laser receiver, read
and observe the laser receiver
operating instructions.
Use with Accessories
and 13.
-15-
Working with the Remote Control
(Accessory)
While pressing the operator buttons, the laser
tool can be brought out of alignment so that
the rotation is briefly stopped. This effect is
avoided when using the remote control 20.
Reception lenses 7 for the remote control are
located on three sides of the laser tool, among
other locations above the control panel on the
front side.
Working with the Tripod (Accessory)
The laser tool is equipped with a 5/8" tripod
mount for horizontal operation on a tripod.
Place the laser tool via the tripod mount 16
onto the 5/8" male thread of the tripod and
screw the locking screw of the tripod tight.
On a tripod 21 with a measuring scale on the
elevator column, the height difference can be
adjusted directly.
Working with Wall Mount/Alignment Unit
(Accessory) (see figure A)
You can also mount the laser tool to the wall
mount with alignment unit 25. For this, screw
the 5/8" screw 28 of the wall mount into the
tripod mount 16 of the laser tool.