Publicité
Les langues disponibles
Les langues disponibles
With the teeth flat against the head, slowly start trimming from the front to the
back. Again, it is better to leave the hair longer the first few haircuts (Fig. 4).
Outlining
You do not need the comb attachment to finish off the cut. Remove the comb
attachment from the appliance for this step.
Comb hair into the style. Position clipper between the side burns and the ear.
Make sure the corner edge of the blade is against the hairline. With the outline of
the hair as your guide. slowly move the clipper over. around, and behind the ears
(Fig. 5).
For the back of the neck and the sideburns, hold the clipper upside down, (see
sketch), and holding it against the skin at the length desired, move downwards.
Cleaning the blades
Hold the hair clipper slightly vertically in front of you, i.e. with the clipper blade at
the front slightly upwards towards you
Press the blades backwards with your thumbs in order to remove the clipper blade
from the casing (Fig. A).
The cutting head and the holder will come off the hair clipper.
Press the white block with the holder to open the clipper blades (Fig. B). Use the
cleaning brush (10) to remove any hair remaining between the blades.
Then place 2 or 3 drops of oil between the blades for lubrication. Push the cutting
head back on until it clicks properly into place.
Switch the appliance on for a couple of seconds so that the oil can be distributed
evenly. Use the oil supplied for lubrication.
The clipper blades should be oiled regularly (or after each time they are used) to
keep the appliance in good order.
Do not use hair oil, grease or any oil mixed with kerosene or other solvent. The
solvent will evaporate, and will leave thick oil, which might then cause the blades
to move more slowly.
Remains of greasiness from the hair itself may also lead to a less satisfactory
cutting process. If this happens, open the clipper blades by pressing an the white
block with the holder, then dip the blades briefly into pure petroleum. Dry the
blades afterwards with a cloth.
25
Publicité
