Publicité
Les langues disponibles
Les langues disponibles
It is better not to cut the hair too short at first, so that you can get used to the
length of cut at each setting.
We recommend that you begin with the longest length of cut (20 mm), and then
select a shorter setting if required.
OPERATION
Preparation
We recommend that you wash the hair first and then cut it after it has been
towel-dried.
Sit the person having the haircut in a chair, so that his or her head is at your eye
level.
First of all, comb the hair so that it fells naturally.
Hold the hair clipper loosely in your hand, so that you always have the correct
degree of control as you cut.
Cutting
Unlock the comb attachment by sliding the cutting length locking switch (6) to
"Unlock". At first, set the length of cut to 20 mm.
Fix the cut length at this setting by moving the cutting length locking switch back to
"Lock". This procedure must be repeated
each time the length of cut is re-set.
Start by trimming the sides from the bottom upwards. Hold the clipper lightly
against the hair with teeth of the attachment
comb pointing up but flat against the head. Slowly lift the clipper up and outward
through the hair
(use a shorter length setting if necessary), cutting only a small amount at a time
(Fig. 1 ).
Repeat around sides and back of head (Fig. 2)
If you want to cut the hair shorter, you have to set a shorter length of cut.
Alternatively, you could use the same setting and press more firmly, then lift the
appliance out more slowly.
This entire procedure requires practice, and it is always better to leave too much
hair the first few haircuts (Fig. 3).
You can use the 10 or 1 2mm hair length setting to cut the top hair on the head
quite short. Use the 4 or 7mm setting to cut crew cuts.
24
Publicité
