Tristar TR-2543 Mode D'emploi page 22

1 Clipperhead
2 ON/OFF switch
3 Charge indicationlamp
4 Chargingposition
5 Cutting length locking switch
6 1 comb attachment for 7 cutting lengths
7 Plug-in charger or direct mains operation
8 Scissors
9 Hairdressing comb
10 Cleaning brush
11 Lubricant oil
Important advice
Before using the clipper for the first time, remove the packaging material and
check that the cutting length locking switch (5)
is switched to `Unlock". You will only be able to fit the comb attachment when the
switch is in this position.
The hair clipper will have been checked carefully before despatch to make sure
that the blades have been oiled.
Charging the battery
Check that the hair clipper has been switched off, i.e. the On/Off switch (2) must
be in the "Off" position.
Place the hair clipper in the charging stand (4). Plug the plug-in charger (7) into a
socket and connect it to the charger
stand. The battery will then start to charge and the charge indication lamp (3) will
glow red.
After it has been charged for about 4 hours, the hair clipper will be able to operate
in cordless mode far about 30-40 minutes. Take the hair clipper out of the
charging stand and switch the On/Off switch to the "ON" position. Switch the
appliance off again after you finish using it.
You can also charge the appliance without using the charging stand. Check that
the appliance is switched off. Plug the plug-in charger (8) into a socket and
connect it directly to the hair clipper. The battery will then start to charge, and the
charge indication lamp (3) will glow red. After it has been charged for about 4
hours, the hair clipper will once again be ready for about 30-40 minutes of
cordless operation. Disconnect the hair clipper from the socket and simply switch
the On/Off switch to the "ON" position. Switch the appliance off again after you
finish using it.
22