Publicité
Les langues disponibles
Les langues disponibles
Mains operation
Check that the appliance has been switched off, i.e. the On/Off switch must be in
the "Off" position. Plug the plug-in charger (7) into a socket and connect it directly
to the hair clipper. Switch the appliance on, and you can then start cutting right
away. Switch the appliance off again after you finish using it.
This option enables you to switch immediately to mains operation if the battery
discharges unexpectedly, allowing you to finish a haircut.
Using the comb attachment
Hold the hair clipper back to front in your hand. Check that the cutting length
locking switch (5) on the base of the hair clipper is in the "Unlock" position. Now
slide the two guide rails on the comb attachment into the depressions in the
casing of the clipper.
The comb attachment can be set to any of 7 lengths far cutting. You can read off
the set length in mm on the attachment (4 to 20mm).
1 . To set the required length, first move the cutting length locking switch to
"Unlock". Place your thumbs on the ribbed surface of the comb attachment and
slide it backwards or forwards until you reach the cutting length you require.
Example: If the small arrow an the hair clipper paints to the arrow indicating
20mm, the set hair cutting length is 20mm, etc.
2. Once you have set the required hair cutting length, you will have to slide the
cuffing length locking switch to the "Lock" position to fix the comb attachment in
this setting.
Use the some procedure each time you change the setting.
Tips for beginners
Practice makes perfect when it comes the haircuts.
Never move the hair clipper quickly through the hair for a standard cut. The
appliance only works at its best if it is pushed gently.
Don't forget to comb through the hair at regular intervals, in order to remove the
small hairs that have already been cut.
While you do this, check that you have been cutting the hair evenly.
23
Publicité
