Charging The Battery Pack; How Do I Check The Battery Power; Using The Stylus - Psion Teklogix NETBOOK PRO Guide De Démarrage Rapide

Until this is done, the battery information control panel will
indicate 'Not calibrated', and the reported capacity will not
be very accurate.
Psion Teklogix recommends that the battery be fully charged
when the unit is first received, then fully discharged before
being charged again, thus calibrating the battery gauge.
Please refer to the NETBOOK PRO User Manual for more
information.

2.10.2 Charging The Battery Pack

To charge the battery, attach the battery pack to the NET-
BOOK PRO and connect the supplied AC adaptor. The
standard (2200 mAH) NETBOOK PRO battery will nor-
mally be fully charged within 3 to 4 hours.

2.10.3 How Do I Check The Battery Power?

To check the battery power:
1. Press the Start button. The Start menu appears.
2. Select Settings, Control Panel.
3. Select the Power icon from the Control Panel. The
Battery tab gives a brief description of the state of
the main battery.
Note: When your NETBOOK PRO is switched off, it is on
"Suspend" and will continue to use a small amount of
battery power. If you are going to leave your NET-
BOOK PRO switched off for a long period of time,
you are advised to back up your data beforehand
because the batteries will eventually run out.

2.11 Using The Stylus

The stylus is located in a recess in the right side of the com-
puter. To remove it, push the square button next to the stylus
and the stylus will pop out. To store it, push the stylus back
into the recess (see Figure 2.8).
Figure 2.8 Stylus Location And Removal
Tap lightly on the screen using the stylus. You can use your
fingers to tap on the screen, though it is best to use the stylus
to avoid fingerprints or smudges on the screen. Do not tap the
screen with any object that has a sharp tip or you may dam-
age the screen. Don't use any type of ink pen, as the ink may
be impossible to remove. See "Caring For The NETBOOK
PRO" on page 11 for instructions on how to clean the screen.
You can usually tap on ("click on") an item with the stylus to
select or change it. For example, you can:
• Double-tap (or click) a program icon, to open a program.
• Press the Alt key, then tap, to right-click.
Note: If the screen doesn't respond to your taps, you may
need to recalibrate it. See recalibration instructions in
the Control Panel/Stylus Properties /Calibration menu.
Psion Teklogix NETBOOK PRO Quick Start Guide 9
Stylus
Stylus Release Button