Polaroid OneStep 2 Mode D'emploi page 9

The flash LED will blink green button, the LEDs will return to
whilst charging between shots, displaying the number of shots
and will be solid green when remaining in your film pack.
ready to shoot.
2. Battery low: Compatible Film
Enough charge for about The OneStep 2 works with
1 pack of film. all Polaroid Originals i-Type
The flash LED will blink orange and 600 type film packs. We
whilst charging between shots, recommend using i-Type film
and will be solid orange when as it is optimized for use with
ready to shoot. the OneStep 2.
3. Battery empty:
Power supply
No charge remaining.
The flash will blink red, Charge the OneStep 2 before
led
and the camera will cease to use to ensure it has enough
operate until it is recharged. power for the duration of your
A fully-charged OneStep 2 shoot (see →Charge the Cam-
camera will have enough pow- era). The flash charge LED will
er to shoot 15-20 packs be solid red whilst the camera is
of film, depending on usage. plugged in and charging, and will
To check the camera's charge turn off once the camera is fully
at any time, switch the camera charged.
off, then switch it back on
Attach the camera neck strap
whilst holding down the
self-timer button. The 8 film See page 8 for guide to attach-
counter LEDs on top of the ing your neck strap.
camera will light up, indicating
how much battery remains. Using a Tripod
For example: If 6 LEDs light The OneStep 2 has a tripod
up, that means the camera has socket in its base, which works
6/8 (75%) charge remaining. with most standard tripods.
Once you release the self-timer Simply screw your tripod
mount into the socket on the 8. Rollers will automatically re-
base of the OneStep 2. turn to their correct position.
Note With most tripods,
the tripod mount will need
Troubleshooting
to be unscrewed before
you can load or exchange
& FAQ
film into the OneStep 2.
Cleaning the rollers My OneStep 2 won't eject
Sometimes excess developer my photo/darkslide
paste from photos may build Make sure that your OneStep 2
up on the camera's rollers, camera is charged: The cam-
affecting the camera's perfor- era's flash charge LED will blink
mance and causing photos to red if it doesn't have enough
show unwanted imperfections. charge to operate. If this is
The OneStep 2 has a built-in the case, you should recharge
roller cleaning mode to help your camera before using the
with this issue. Just follow camera again.
these steps: Make sure you still have
1. Turn the camera off. film in your camera: to check,
2. Open the film door. slide the power switch off and
3. Hold the flash override button on. The remaining film counter
and press the shutter button. LEDs will indicate how many
4. The camera is now in roller shots you have left in the film
cleaning mode. pack. If the LEDs flash rapidly
5. Using a damp cloth or cotton when the the camera turns on
swab, gently clean the rollers. again, this means that there are
6. Press shutter button to no shots left in the film pack, or
incrementally advance roller that no film pack is inserted.
positions.
7. Once both rollers are clean on
all sides, close the film door.