Polaroid OneStep 2 Mode D'emploi page 8

the exposure of your shot. To shooting at distances of
get a brighter photo, move the 1.2 meters or less.
lighten/darken switch right to
the plus/lighten position. For a 6. Compose your photo
darker photo, move the light- To avoid a blurry photo, make
en/darken switch left to the sure you are at least 60cm (2
minus/darken position. These feet) away from your subject
two settings correspond to when you take the picture. For
different Exposure Values (EV). the best results, always try to
The camera's Exposure Values shoot with your light source
are +½ EV (when you move the behind you.
switch to plus/lighten) and -½
7. Take the photo
EV (when you move the switch
to minus/darken). Press the shutter button all
the way in to take the photo.
5. Using the viewfinder The photo will be ejected from
The OneStep 2 uses a tra- the slot at the front of the
ditional viewfinder located camera as soon as you let go
on the right side of the lens of the shutter button. It will be
barrel. The viewfinder is most shielded from the light by the
accurate when you align your film shield, and will be held in
right eye with the space behind place until you are ready to
the viewfinder. remove it.
Note Remember that the
8. Remove and shield
viewfinder sits slightly
above and to the right of the photo
the camera's lens — above Remove the photo from
and to the left from your beneath the film shield and let
perspective when shooting the film shield roll back into the
— so you will need to adjust camera. Place the photo face
your aim to compose down to continue shielding it
your shot correctly when from light as it develops.
Further Guidance
override button as you
press the shutter button.
Using the self-timer
The OneStep 2 has a self-timer How much film is left
function allowing you to place in the pack
yourself in your photos or There are 8 orange LED lights
create perfectly-timed photo- on top of the camera. When the
graphs. To use the self-timer, OneStep 2 is switched on and
press the self-timer button on not in sleep mode, the LEDs
the left of the lens barrel. The will constantly display the film
self-timer button will light up to count. The number of LEDs
solid orange, indicating that the which light up corresponds
self-timer is activated. Once to the number of shots left in
you have framed your photo, the film pack. For example: If
press the shutter button. The 6 LEDs light up, that means
self-timer uses an 8-second there are 6 shots left in the film
interval between pressing the pack. If you have used up all
shutter button and taking the 8 shots in the film pack, or if
photograph. Once triggered, there is no film pack inserted in
the self-timer's orange LED will the camera, then the LEDs will
blink to indicate the self-timer blink rapidly when you turn the
countdown. In bright or sunny camera on.
environments, the camera
How much battery
flash will also countdown with
you have left
short, low-power flashes.
Note When using the The camera has 3 bat-
self-timer to shoot, the tery states, indicated by
flash will trigger automat- the camera's flash charge
ically. To make self-timed LED light:
photos without flash, 1. Battery charged:
activate the self-timer, then Enough charge for at least 2
press and hold the flash packs of film.