Dolmar PS-32 C Manuel D'emploi Et De Sécurité page 34

α
1
34
Chain type
092
290
2
Files and how to work with them
Use a special saw chain round file for sharpening. Standard
round files are unsuitable. See "Extract from the spare parts
list".
Type 092: Saw chain round file, dia. 5/32" (4.0 mm).
Type 290: Saw chain round file, dia. 11/64" (4.5 mm).
The file should cut only when pushed forwards (arrow). Lift
the file when leading it backwards.
First sharpen the shortest cutter. The length of this cutter is
then the standerd for all other cutters of the chain.
New saw teeth must be filed to the exact same shape as the
used teeth, including on their running surfaces.
File depending on chain type (90° to the guide bar).
A file holder makes file guidance easier. It is marked for the
4/5 correct sharpening angle of:
α = 25°
α = 30°
α = 35°
(keep the marks parallel with the chain when filing, see illus-
tration) and limits the cut depth to the correct 4/5 of the file
diameter. See "Extract from the spare parts list".
After having sharpened the chain, the height of the depth
limiter must be checked by means of a chain gauge. See
"Extract from the spare parts list".
Correct even the smallest excess height with a special flat
file (1). See "Extract from the spare parts list".
Round off the front of the depth limiter (2).