Nice Era Star T Instructions Et Avertissements Pour L'installation Et L'utilisation page 8

• (It disables the "RDC" function)
01. Use the Up or Down button to move the awning to the point of mid-travel.
02. Press and hold Up and wait for the awning to stop automatically at limit switch "0" (do not release the button!).
03. With the Up button still pressed, press and hold the Down button at the same time and wait for the awning to complete a short down movement; then release the
two buttons.
04. Press and hold the Up and Down buttons simultaneously and wait for the awning to complete two short movements: one up movement and (after a few seconds)
one down movement, until it stops again in the set position. Then release the two buttons.
05. Press and hold both the Up and Down buttons simultaneously until the awning performs a short up movement. Then release the two buttons.
06. Use the Up and Down buttons again to move the awning to disconnect position "S".
07. Press and hold the Up and Down buttons simultaneously and wait for the awning to complete two short movements: one up movement and (after a few seconds)
one down movement, until it stops again in the set position. Then release the two buttons.
01 02
03
05
1
5
sec.
07
2
5
sec.
5.8 - Awning with MANUAL hook-up of fabric on opening: "FTA" function
This function has been developed exclusively for awnings with a manual mechanism to block the canvas in the opening position (for exam-
ple the mechanism on awnings with straight arms, on arbour awnings etc.). The motor enables memorisation of only one hook-up position. If the
function is active, during closure the motor is stopped automatically as soon as the awning comes into contact with the blocking mechanism on its
route. To then release the awning, press the Down button, wait for the awning to reach limit position "1", release the mechanism manually and close
the awning by means of the Up button.
Caution! - The "FTA" function can only be set after programming the limit position values "0" and "1". When "FTA" is active, the "RDC"
function acts on the entire travel of the awning.
01. Use the Up or Down button to move the awning to the point of mid-travel.
02. Press and hold the Up and Down buttons simultaneously and wait for the awning to perform a short movement, a pause and then a second short move
01 02
03
"0"
( )
"1"
"1"
S
06
THE
END
1
5
sec.
1
5
sec.
04
2
5
sec.
( )
"1"
S
THE
END
1
"S"
English – 7