Measuring Object/Ambient Temperature; Other; Automatic Switch-Off - Reer SoftTemp Instructions

Fever warning
The thermometer has an optical LED warning indication
installed that warns in case of increased body temperature.
LED colour
Green
Orange
Red
If the LED on the device lights up red during the tem-
perature measurement, the body temperature should be
constantly monitored and a physician should be consul-
ted if the condition of the person is ambiguous.
Use of this device in no way replaces a physician's
examination. Always see a doctor in case of high fever or
ambiguous measuring results.
Measuring object/
ambient temperature
Liquids should be measured outside the container, if possible, to
avoid the deposition of moisture on the sensor.
The device is not water-proof and thus must not be
immersed in water or directly in liquid.
The „object/ambient temperature" mode only displays
the radiation temperature of the surface/room tempera-
ture and does not give any indication regarding the body
temperature. This measuring mode thus cannot be used for
measuring a fever temperature.
18
Body temperature measured
Normal body temperature:
36,3°C – 37,3°C (97,3 – 99,1°F)
Slightly increased body temperature:
37,4°C – 37,9°C (99,2 – 100,2°F)
Increased body temperature:
≥ 38°C (100,3°F)

Other

Automatic switch-off

After about 30 seconds of inactivity, the device switches off.
30
sec
Measured value memory
The thermometer automatically saves the temperature
values of the last 19 measurements. If the 19 memory slots
are exceeded, the oldest available value is overwritten.
1
press!
2
press!
3
press! press! press!
4
press!
Signal tone
press!
Switching from °C to °F
press!
max. 19 memory slots
press!
°C / °F
press!
19