Product Maintenance - Fellowes POWERSHRED DS-1200Cs Mode D'emploi

ADVANCED PRODUCT FEATURES
SafeSense ® Technology
Stops shredding immediately when
hands touch the paper opening.
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Set to Off (O) * Apply oil
across entry
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the
continuous operation and recovery time for this shredder.
SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense
PAPER JAM
1 2
Set to Reverse (R)
for 2-3 seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
SET-UP AND TESTING
1
Set to Auto-On (I)
3
Set to Reverse (R)
2-3 seconds
3
Alternate slowly back and forth
2 3
12 12
Touch test area and SafeSense is active
®
look for the SafeSense ® and working properly
indicator to illuminate
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1 2
Turn off and unplug Locate Auto-start
shredder infrared sensor
® indicator will illuminate and the shredder will stop shredding.
4 5
Set to Off (O) Gently pull uncut paper
and unplug from paper entry. Plug in
additional costs incurred by Fellowes to provide parts or services outside of the country where the
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
more details or to obtain service under this warranty, please contact us or your dealer.
.
4
3
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
6
Set to Auto-On (I) and
resume shredding
3