Shindaiwa T230 Manuel De L'opérateur page 8

Assembly
Handle T230/T230s
1. Position the handle on the outer tube
forward of the Handle Positioning Label
as shown.
. Install the barrier bar with the socket
head cap screws and nuts. Tighten the
screws finger-tight ONLY at this time.
3. Locate the handle in the best position
for operator comfort (usually about 10
inches ahead of the throttle housing).
4. Secure the handle by alternately tighten-
ing the four socket-head screws in a
diagonal or "criss-cross" fashion.
Assembly
Cutting Attachment Shield
Assemble the Cutting Attach-
ment Shield to the Outer Tube.
(A) Cutting Attachment Shield
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
NOTE:
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting attach-
ment shield mounting plate.
. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
CAUTION!
Make sure the clamp screw and retain-
ing nut is securely tightened before
tightening the four socket head screws.
3. Tighten the four socket-head cap screws
to secure the cutting attachment shield.
WARNING!
NEVER operate a trimmer or brushcutter
without the cutting attachment shield
installed and tightly secured!
(B) Shield Extension (when trimmer head
is in use)
(1) Attach the shield extension to the cut-
ting attachment shield.
8
Socket-Head
Cap Screws
Outer Tube
23028
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Retaining
Nut
Cutting Attachment Shield
Shield Extension
Handle
Nut
Barrier Bar
Outer
Tube
Shim
Cutting Attachment
Shield Mounting Plate
Hook Receiver
Hook
Throttle
Assembly
Handle Positioning Label
Cutting
Attachment
Shield