Assembly - Shindaiwa T230 Manuel De L'opérateur

Assembly

Driveshaft/Powerhead
Connect the Outer Tube to the
Powerhead.
1. Place the powerhead on a clean, flat
surface, spark plug facing up.
. Use the 4mm hex wrench to loosen
the tube
clamp screw.
Verify that
the D-shaped
shim washer
is positioned
as shown.
Hex
Wrench
CAUTION!
Do not remove the D-shaped shim
washer! The shim washer prevents
damage from overtightening the tube
clamp screw.
Assembly
Handlebar C230/C230s
Assemble the Handlebar.
1. Position the handle bracket against the
handle label located on the outer tube.
. Attach the handle mounting bracket
using the two socket-head cap screws.
Tighten the screws finger-tight ONLY at
this time.
3. Locate the handle forward of the Handle
Positioning Label at the best position for
operator comfort.
4. Using the hex wrench, securely tighten
the two handlebar cap screws.
5. Route the ribbed throttle cable tube
along the handlebar and outer tube.
Install the protector sleeve on the outer
tube.
Tube Clamp
D-shaped
Shim Washer
CAUTION!
Do not force the shaft tube into the
powerhead! Excessive force can
damage the shaft tube and mainshaft.
3. Add some moly-type EP grease to the
splines on the end of the mainshaft.
Throttle
Trigger
Throttle
Cable
Clamp must fit next to line
on outer-tube decal
Decal
Clamp
C230/C230s Brushcutter
Ignition Switch
Shoulder Strap
Outer Tube
Main
Shaft
Tube
Clamp
Clamp
Outer Tube Screw
T230/T230s Shown
4. Slide the outer tube into the tube clamp
until the tube bottoms and the installa-
tion decal aligns with the tube clamp. If
installation is difficult, rotate the outer
tube or mainshaft slightly until you feel
the mainshaft splines engage with the
powerhead.
5. Position the outer tube so that the gear
Case output shaft is facing down.
6. Tighten the clamp screw firmly.
Hanger
Handlebar
Mounting Bracket
Socket-Head Cap
Screw
Spark Plug
7