Thermador PROFESSIONAL VCIN60RP Instructions D'installation page 18

Remote Control Installation
2. Access the wiring.
a) Remove filters and grease trays.
b) Remove the junction box cover, as shown below.
c) Remove the screws holding the stainless steel
panel to the canopy.
d) Remove the core partition.
Installation Instructions
Figure 21: Junction Box Cover
Figure 22: Remove Canopy
Figure 23: Core Partition
2. Connect the harness to the relay board.
a) Unplug the
user interface
harness to the
relay board.
b) Plug in the
smaller end of a
3 ft. input/power
harness,
included in the
remote kit.
3. Route the other end of the 3 ft. input/power harness
through the core partition access hole.
4. Reinstall core partition after running the harness
through the access hole.
Figure 24: Access Hole
English | 17 |