Clamping Correctly - Allmatic NC8 Serie Instructions De Service

ALLMATIC
8.4.2

Clamping Correctly

Fig. 22: Position workpiece axis
Workpiece correctly clamped
Workpiece clamped off centre.
Risk of damage to the jaws and the workpiece.
Ø Clamp workpiece centrally.
Fig. 23: Positioning of workpiece axis
Workpiece correctly clamped
Workpiece clamped at an angle.
Risk of damage to the jaws and the workpiece.
Ø Only clamp the workpiece when lying flat.
Ø Only clamp workpieces of a suitable size.
NC8 Series
Workpiece incorrectly clamped
Workpiece incorrectly clamped
Clamping | 8
EN
63 / 410