Startup Procedure - Mettler Toledo GA42 Mode D'emploi

Startup procedure

1
1 2
DLS–2
2
GA42 Printer
GA42 Instrument
RS232C
4
Configuring the interface
• Open cover of paper compartment (1) and remove paper roll.
• Press plastic tab (2) backward and open the battery compartment cover.
• Leave DIP switch 1 in the OFF position! It has no meaning.
• Set DIP switch 2 of the printer accordingly.
ON: For DL36 KF Coulometer, DL31 / 38, DL50 Graphix, DL50 / 53 / 55 / 58 Titrators
MP125, MA130, MC126, MO128 portable Meters
DELTA 340 / 345 / 350 / 355 pH Meters
DA-100M / 300M / 310M, DE40 / 50 / 51 Density Meters
RE20B / 40 / 50 Refractometers
OFF: For DL18 / 20 / 21 / 25 / 35 / 40 / 40RC / 40GP Titrators
QUATTRO MP225, MP230, MA235, MC226, MPC227
RA-510M Refractometer
FP62 Melting Point Instrument and FP800 / 800HT Thermosystems
all METTLER TOLEDO balances with an RS232C interface
Inserting paper
• Feed paper through the slot in the printing unit in the direction of the arrow.
• Switch on printer with toggle switch at the rear.
• Press and hold until sufficient paper has been fed in.
Attaching the printer
• Attach connection cable of the GA42 to the printer interface of the instrument and to the printer.
After configuring the attached instrument for the GA42, the printer is ready for operation.
Order numbers for connection cables, see page 7.