Meec tools 071016 Traduction Du Mode D'emploi Original page 23

IMPORTANT! Disconnect the tool from the air supply before carrying out any service procedures.
PROBLEM
Air leakage near the top of
the tool or at the trigger.
The tool does not work or
operates sluggishly.
Air leaking at the bottom of
the tool.
Nails often jam in the tool. Incorrect
Other.
ENGLISH
TROUBLESHOOTING
CAUSE
Loose screw
connections.
O-ring or seal is worn
or damaged.
Low air pressure.
Inadequate
lubrication.
O-rings or seal are
worn or damaged.
Loose screw
connections.
O-rings or seal are
worn or damaged.
fasteners
loaded.
Damaged fasteners.
Magazine or nose
screws loose.
Magazine is dirty.
Driver is worn or
damaged.
ACTION
Tighten the screws.
Replace damaged or worn parts.
Check that the air pressure supply is correct. Put 5 or
6 drops of oil into the air inlet. Install TOP
maintenance kit.
Tighten the screws.
Replace damaged or worn parts.
Use approved fasteners of correct size.
Replace with undamaged fasteners.
Tighten the screws.
Clean the magazine.
Replace damaged or worn parts.
Contact your local agent.
23