ABB Sonde Ammoniac 8002 Manuel D'instructions page 2

The Company
We are an established world force in the design and manufacture
of instrumentation
measurement, gas and liquid analysis and environmental
applications.
As a part of ABB, a world leader in process automation
technology, we offer customers application expertise, service and
support worldwide.
We are committed to teamwork, high quality manufacturing,
advanced technology and unrivalled service and support.
The quality, accuracy and performance of the Company's
products result from over 100 years experience, combined with a
continuous program of innovative design and development to
incorporate the latest technology.
The NAMAS Calibration Laboratory (No. 0255) is just one of ten
flow calibration plants operated by the Company, and is indicative
of our dedication to quality and accuracy.
Use of Instructions
Warning.
An instruction that draws attention to the
risk of injury or death.
Caution.
An instruction that draws attention to the
risk of damage to the product, process or
surroundings.
Although Warning hazards are related to personal injury, and Caution hazards are associated with
equipment or property damage, it must be understood that operation of damaged equipment could,
under certain operational conditions, result in degraded process system performance leading to
personal injury or death. Therefore, comply fully with all Warning and Caution notices.
Information in this manual is intended only to assist our customers in the efficient operation of our
equipment. Use of this manual for any other purpose is specifically prohibited and its contents are not to
be reproduced in full or part without prior approval of the Technical Publications Department.
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:
1. The relevant sections of these instructions must be read carefully before proceeding.
2. Warning labels on containers and packages must be observed.
3. Installation, operation, maintenance and servicing must only be carried out by suitably trained
personnel and in accordance with the information given.
4. Normal safety precautions must be taken to avoid the possibility of an accident occurring when
operating in conditions of high pressure and/or temperature.
5. Chemicals must be stored away from heat, protected from temperature extremes and
powders kept dry. Normal safe handling procedures must be used.
6. When disposing of chemicals ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual or any relevant hazard
data sheets (where applicable) may be obtained from the Company address on the back cover,
together with servicing and spares information.
for industrial process
ABB
control, flow
Note.
Clarification of an instruction or additional
information.
Information.
Further reference
information or technical details.
EN ISO 9001:2000
Cert. No. Q5907
EN 29001 (ISO 9001)
Lenno, Italy – Cert. No. 9/90A
for more detailed