TTI TSX Serie Manuel D'instructions page 26

∗SRE <nrf>
Sequential command.
Operation complete message generated immediately after execution.
Set the Service Request Enable Register to <nrf>. If the value of <nrf>, after rounding, is less
than 0 or greater than 255 an execution error is generated and error number 119 (Value out of
range) is placed in the Execution Error Register.
∗SRE?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the value of the Service Request Enable Register in <nr1> numeric format. The syntax of
the response is
Example.
∗STB?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the value of the Status Byte Register in <nr1> numeric format. The syntax of the
response is
Example.
∗SAV <nrf>
Sequential command.
Operation complete message generated immediately after execution.
Save settings to store number <nrf>. The instrument settings are saved in the store pointed to by
<nrf>. If the value of <nrf>, after rounding, is less than 1 or greater than 25 an execution error is
generated and error number 115 (illegal store number) is placed in the Execution Error Register.
The scope of the ∗SAV command is as follows:
The output is set to stored values of Volts, current, OVP, delta V and delta A.
The output status is set to the stored value.
∗TST?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Examine the state of the FLT bit in the Status byte register and return the result. If the bit is clear
the response is
any failure is indicated by a non-zero FLT bit and the response will be
The value in the FLT bit is 1 if an execution error 002 has been reported since the instrument was
powered up.
If the Service Request Enable Register contains 01000001b the response to
∗SRE? will be 65<rmt>.
If the Status Byte Register contains 01000001b the response to ∗STB? will be
65<rmt>.
<nr1><rmt>
<nr1><rmt>
0<rmt>
1<rmt>
25