Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Plug cord into wall receptacle. Your humidifier is now ready for use. The
humidifier should be placed at least FOUR inches away from any walls and away
from heat registers. Unrestricted airflow into the unit will result in the best
efficiency and performance.
NOTE: This unit has an automatic humidistat located on the cord that senses the
humidity level around the immediate area of the humidifier. It turns the humidifier
on when the relative humidity in your home is below the humidistat setting and
will turn the humidifier off when the relative humidity reaches the humidistat
setting.
CONTROL PANEL
TO TURN ON/OFF
HUMIDITY CONTROL
3) The hygrometer on the cord reads the current room humidity and displays
the percentage on LCD panel.
4) To set the desired humidity, press the
increases the humidity in 5% increments. The range is 25% to 65%.
5) At 65% the humidifier will run constantly with or without water.
NOTE: If excessive condensation occurs, reduce fan to a lower speed setting.
CAUTION: Disconnect power before filling, cleaning or servicing unit.
Keep grille dry at all times.
CHECK FILTER
The ability of any humidifier to efficiently supply humidity output relies heavily on
the condition of the filter. As the filter loads with impurities it gradually loses its
wicking capability. When this happens, moisture output is reduced and the
humidifier has to work longer to satisfy the selected setting.
This humidifier has a check filter reminder timed to appear after
720 hours of operation. When the Check Filter (CF) message is
displayed, disconnect the power cord and check the condition of
the filter. If a build-up of deposits or severe discoloration is
evident replace the filter to restore maximum efficiency.
The CF function is reset after plugging the unit back in.
For initial operation, plug the unit
in (the display will show - -). Press
the
button to turn the unit on
or off.
FAN SPEED
The 7D6100 has a four speed
digital control panel.
1) Press the
adjust the fan speeds
2) The speeds: High (F4) – Low
(F1) display on the digital panel.
A display of "00" indicates the
fan is in standby and can be
adjusted as desired.
button. Each successive push
6
button to
Publicité
Table des Matières
