Control Panel; Humidity Control - Aircare 831000 Manuel D'utilisation Et D'entretien

OPERATION
Note: Place the unit at least FOUR inches away from any walls or curtains.
Unrestricted airflow into the unit will result in the best efficiency and performance.
Display Panel: Humidity Display, Refill Indicatio
and Fan Indication

CONTROL PANEL

The digital controller has a display that provides information on the status of the unit.
Depending on which function is being accessed, it displays relative humidity, fan speed,
set humidity and indicates when the unit is out of water.

HUMIDITY CONTROL

NOTE: This unit has an automatic humidistat that cycles the humidifier on
and off as required to maintain the selected setting.
2) At initial startup the relative humidity of the room will be displayed.
Each time you push the Humidity Control Button the setting will increase in 5%
increments. At 65% set point, the unit will operate continuously.
FAN SPEED
3) The 831000 unit has a 3-speed fan. The display shows F1, F2 or F3.
Use the lowest setting for the quietest operation or a highest setting for
maximum output.
NOTE: When excessive condensation exists, a lower speed setting is recommended.
CAUTION: Disconnect power before cleaning or servicing unit. Keep grille dry
at all times.
OTHER INDICATIONS
4) This humidifier has a check filter reminder timed to appear after 720
hours of operation. When the Check Filter (CF) message is displayed,
disconnect the power cord and check the condition of the filter. The CF
function will reset after the unit is plugged back in.
5) The control will display a flashing "F" when the water reservoir is
empty.
AUTO DRYOUT
At this time the unit will automatically switch into AUTO DRY OUT MODE and
continue to run on the lowest speed until the filter is completely dry. The
fan will shut off leaving you with a dry humidifier that is less prone to mold
and mildew. During the AUTO DRYOUT mode the room humidity level will
continue to be monitored and the humidifier will cycle the fan on and off until the filter
is completely dry. If you do not wish this feature to engage, refill the unit.
1) Plug cord into wall receptacle.
NOTE: This unit has an adjustable
Fan Speed humidistat located in the control that
Button
senses the humidity level around the
Humidity
immediate area of the humidifier. It turns
Control
the humidifier on when the relative
Button
humidity in your home is below the
Power
humidistat setting and will turn the
Button
humidifier off when the relative humidity
reaches the humidistat setting.
6
Your humidifier is now ready
for use.