Erase Memory - BGS technic 8980 Mode D'emploi

DISPLAY
A Battery indicator (3 steps)
B Memory step
C Maximum value
D Pressure value or information
E
Indicator for the selected unit of measure
FUNKTION KEY / DISPLAY
INSTALL BATTERY
The Display shows „Init Syst" for approx. 1 sec. when installing the battery.
SWITCH ON
Press the button PWR short, the dial indicator is switched on and the display
shows „turn on" for approx. 1 sec.
SWITCH OFF
Press PWR button for longer than 2 sec., to switch on the dial gauge.
SELECT UNIT
Press the Unit button short, after the dial indicator is switched on, to select the desired unit of
measure.
MEMORY
Press the MEM button short, to safe the value and change the memory index.

ERASE MEMORY

Press CLR button for longer than 2 sec., to clear all memories and pressure
offset. The display shows CLr.
LED
Press the LED button short, to switch on or off the backlight.
ZERO
Press Zero button for longer than 2 sec., to delete the complete memory.
The display shows 2Ero.
BATTERY VOLT
Press Unit/PWR and MEM/CLR button at the same time to see the current
battery volt.
IDENTIFICATION
Press Unit/PWR and LED/Zero button at the same time to see gauge ID in hex
digit.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed