Intended Use; Safety Informations; Pressure Gauge - BGS technic 8980 Mode D'emploi

INTENDED USE

The compression tester is a valuable tool for the diagnosis of engines, which can be both age-related
and tear as well as leakage of the piston rings and valves notice. Through the adaptation of the
compression tester has a wide range of application such as. e.g. diagnosis of cars, motorcycles and
other machines with 2- or 4-stroke engines.

SAFETY INFORMATIONS

Read the following safety instructions carefully before using the product. Failure to observe the safety
instructions can result in damage, injuries and void the warranty.

Take care when checking hot engines, there is a risk of burns on the hot exhaust manifold or
other hot engine parts!

Be careful with running engines, loose or baggy clothing can be caught in rotating parts and
cause injuries.

Only work in a well-ventilated area. Do not inhale exhaust gases and fuel vapors.

Always be careful when working on fuel systems. The fuel in the fuel line may be pressurized
even when the engine is not running.

These operating instructions provide general tool information. Always refer to the vehicle-
specific service literature, this contains data, repair instructions and special warnings.

Before starting repairs, secure the vehicle against accidental starting. (Remove ignition key or
disconnect battery)

Keep children and other unauthorized persons away from the work area.

Do not let children play with the tool or its packaging.

Always keep a fire extinguisher nearby. This must be suitable for fuel-related, electrical or
chemical fires.

Do not smoke during repairs. Smoking and open flames can lead to fire.

Always keep tools in the case and in a safe, dry place out of the reach of children.

Disconnect the supply voltage to the ignition coils and the petrol injection nozzles.

Disconnecting the high voltage ignition cables alone can damage the ignition system, cause
fire and electric shock.

PRESSURE GAUGE

8 Display shows value in selected unit
9 Button
LED/ZERO
10
Button MEM/CLR: Value memorizing / Delete memory
11 Button
Unit/PWR
12 Pressure release valve
13
Quick coupler release ring
14 Quick coupler
SHORT DESCRIPTION OF FUNCTION KEYS
LED / ZERO
Button (9)
MEM / CLR
Button (10)
Unit / PWR
Button (11)
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
: Switched backlight on or off / Set value to zero
: Switch on gauge / Select measuring unit
Press short; Switched On / Off the backlight.
Press longer than 2 sec.; Delete the memory and set the gauge to 0
Press short; Save value and change memory index
Press longer than 2 sec.; Delete the memory
Press short; Select the measuring unit
Press longer than 2 sec.; Switched gauge on
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed